| /* | |
| Blink | |
| Turns on an LED on for one second, then off for one second, repeatedly. | |
| Most Arduinos have an on-board LED you can control. On the Uno and | |
| Leonardo, it is attached to digital pin 13. If you're unsure what | |
| pin the on-board LED is connected to on your Arduino model, check | |
| the documentation at http://www.arduino.cc | |
| This example code is in the public domain. | |
| modified 8 May 2014 | |
| by Scott Fitzgerald | |
| modified by Marco Brianza to show the remote sketch update feature on Arduino Due using Yún Shield | |
| */ | |
| // the setup function runs once when you press reset or power the board | |
| void setup() { | |
| checkForRemoteSketchUpdate(); | |
| // initialize digital pin 13 as an output. | |
| pinMode(13, OUTPUT); | |
| } | |
| // the loop function runs over and over again forever | |
| void loop() { | |
| digitalWrite(13, HIGH); // turn the LED on (HIGH is the voltage level) | |
| delay(100); // wait for a second | |
| digitalWrite(13, LOW); // turn the LED off by making the voltage LOW | |
| delay(100); // wait for a second | |
| } | |