| /*============================================================================== | |
| * NETWORK CONFIGURATION | |
| * | |
| * You must configure your particular hardware. Follow the steps below. | |
| * | |
| * By default, StandardFirmataEthernet is configured as a TCP client. | |
| * To configure as a TCP server, see STEP 2 | |
| *============================================================================*/ | |
| // STEP 1 [REQUIRED] | |
| // Uncomment / comment the appropriate set of includes for your hardware (OPTION A or B) | |
| // Option A is enabled by default. | |
| /* | |
| * OPTION A: Configure for Arduino Ethernet board or Arduino Ethernet shield (or clone) | |
| * | |
| * To configure StandardFirmataEthernet to use the original WIZ5100-based | |
| * ethernet shield or Arduino Ethernet uncomment the WIZ5100_ETHERNET define below | |
| */ | |
| EthernetClient client; | |
| /* | |
| * OPTION B: Configure for Arduin Yun | |
| * | |
| * The Ethernet port on the Arduino Yun board can be used with Firmata in this configuration. | |
| * | |
| * To execute StandardFirmataEthernet on Yun uncomment the YUN_ETHERNET define below and make | |
| * sure the WIZ5100_ETHERNET define (above) is commented out. | |
| * | |
| * On Yun there's no need to configure local_ip and mac address as this is automatically | |
| * configured on the linux-side of Yun. | |
| * | |
| * Note that it may take several seconds to establish a connection with the Yun. | |
| */ | |
| //#define YUN_ETHERNET | |
| YunClient client; | |
| // STEP 2 [REQUIRED for all boards and shields] | |
| // TCP Client configuration: | |
| // To configure your board as a TCP client, set the IP address of the server you want to connect to. | |
| // TCP Server configuration: | |
| // To configure your board as a TCP server, comment out the following line and also ensure that | |
| // remote_host is also commented out. | |
| // *** REMOTE HOST IS NOT YET WORKING *** | |
| // replace with hostname of server you want to connect to, comment out if using 'remote_ip' | |
| // #define remote_host "server.local" | |
| // STEP 3 [REQUIRED] | |
| // Replace with the port that your client or server is listening on. | |
| // STEP 4 [REQUIRED unless using DHCP] | |
| // Replace with your board or ethernet shield's IP address | |
| // Comment out if you want to use DHCP | |
| // STEP 5 [REQUIRED] | |
| // replace with ethernet shield mac. Must be unique for your network | |
| const byte mac[] = {0x90, 0xA2, 0xDA, 0x00, 0x53, 0xE5}; | |
| /*============================================================================== | |
| * CONFIGURATION ERROR CHECK (don't change anything here) | |
| *============================================================================*/ | |
| /*============================================================================== | |
| * PIN IGNORE MACROS (don't change anything here) | |
| *============================================================================*/ | |
| // ignore SPI pins, pin 10 (Ethernet SS) and pin 4 (SS for SD-Card on Ethernet shield) | |